10 in2010 shawl, Sztuka, hobby, Robótki ręczne, ✦✦ DRUTY I SZYDEŁKO, Chusty

[ Pobierz całość w formacie PDF ]
10 in 2010 - shawl
by
Janine Le Cras
Materials:
800yds laceweight yarn
sample knitted in Malabrigo laceweight –
colourway Applewood
Removable markers
US #4 ,3.5mm circular needle
Gauge:
Stockinette
7sts per inch using US #4 ( 3.5mm needles) or size needed to acheive gauge
Method:
Using US #4 ,3.5mm circular needle, cast on 3 sts, work 6 rows garter st. Pick up 3
sts up the side edge of the garter st band and 3 further sts across the cast on edge.
(9 sts in all)
Next row: K3, pm, p1, pm, p2, pm, k3.
These markers will mark the garter st edging
and the centre stitch of the pattern.
Begin the set up chart at row 1.
K3, slip marker, work row 1 of chart, slip marker, knit centre st. Work row 1 of chart
again, slip marker, k3.
Please note that the pattern is the same on either side of the centre stitch. once you
reach the centre you can work the chart again as shown from right to left.
The charts only show RS rows.
All WS rows are worked as follows:
K3, sm, purl across row slipping the marker in the centre, work to last marker, sm,
k3.
Work rows 1 – 20 once. This is
the set up chart for the body of
the shawl.
Setup Chart
Work rows 21- 40. Repeat
rows 21 – 40 , 7 times in all,
adding extra repeats of the
centre portion between the red
lines as needed. Work rows 21 –
40 once more until you have 184
sts on each side of the shawl –
including the 3 garter st border
sts, not including the centre st.
Work transition chart once,
repeating the center section
between the red lines as many
times as necesarry (20 rows).
You have 204 sts on each side
of shawl - including the 3 garter
st border sts, not including the
centre st.
Work edging chart once
repeating the center section
between the redlines as many
times as necesarry (48 rows).
You have 252 sts on each side
of shawl - including the 3 garter
st border sts, not including the
centre st.
Using a needle 2 or 3 sizes
larger, cast off all sts.
Block the shawl pinning out the
points on the two lace edges
and keeping the garter st edge
straight.
Sew in all ends.
Transtion chart A
Transtion chart B
If you wish you can make
things easier by chopping
up this page and taping
the three charts together
in order
A, B, then C
Transtion chart C
Edging Chart A
Edging Chart B
Edging Chart C
Again you may ind it easier to cut these pages up and
tape the 3 charts together
[ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • marucha.opx.pl